Cotherm Type Tse Manual Meat

Posted on by

Air & water heating controls, temperature controller. Appliance manufacturers around the world choose Cotherm for reliability & quality. TSE TSR Series Instructions. Manual Reset Security Cutout. Home Heating Spares are the official distributor of Cotherm Spares and the TSR megaflo TSR00009. Cotherm immersion elements, plug-in thermostats, TSDR, TSE and TSR for use in electric water heater and heat pump applications. The Cotherm TSE00187 thermostat is CE marked and. Looking for a cotherm type tse 099 1509 written on the side but i cannot find on your web site?

Can a Thermostat be changed without draining the complete Cylinder? Yes • Ensure the power supply is isolated before removing the immersion heater cover. • Disconnect the electrical connections from the thermostat body. • Carefully withdraw the thermostat and replace with a suitable new thermostat.

• Reconnect the electrical connections, ensuring these are adequately Note – With Plug in thermostats resistance will be felt when with removing the faulty thermostat, care should be taken not to twist the thermostat from side to side during its removal. When replacing the plug thermostat with a replacement care must be taken to ensure correct location of the male tag into the tightened female Tag. What are the temperature setting on a Cotherm TSE 00187 Thermostat? A. 1 = 10°C, 2 = 25°C, 3 = 40°C, 4 = 55°C & 5 = 70°C Q. How do I connect the wiring to a Cotherm TSE00187 Thermostat? A. A = Live (Brown)  B = Neutral (Blue) Q.Is there a reset button on a Cotherm TSE00187 Thermostat?

Cotherm Thermostat

Yes It is situated above the number 1 on the temperature scale and is marked (Safety) Q. What are the temperature settings on a Thermowatt RTS3 Thermostat? A. Operating Trip – Single Dot is the lower limit and Double Dot is the higher limit. Red Dial 52° – 60°C (75°C Safety Cut-Out) Blue Dial 63° – 71°C (85°C Safety Cut-Out) Yellow Dial 52° – 60°C (70°C Safety Cut-Out) RTS Plus 52° – 60°C (90°C Safety Cut-Out) Q. Is there a reset Button on a Thermowatt RTS3 Thermostat? Yes it is situated in a small recess above the temperature control dial Q. My Immersion Heater needs replacing how I know what to buy?

All our Immersion heaters have a product code either on the side wall of the cover or on the top of the cover. Memorex Electronics Npower Games Of Thrones here.  This code will be a series of letters and numbers please see images. Q. Do all domestic Immersion Heaters require a second level of protection against over temperature operation? A. Yes this can take 3 different forms. • Single Dual function thermostat • Single control thermostat and separate over temperature manual reset button cut out.

• Single control thermostat with a second manual reset over temperature thermostat. I can not find the product code for my immersion heater what information do I need to purchase the correct replacement? You will need to know the length of your immersion heater, the Power rating in watts, the size of the thread of the brass boss and whether your hot water system is vented or unvented Q. How do I tell if my hot water system is vented or unvented? Unvented cylinders work directly from the mains supply of water and are essentially a hot water storage cylinder; where as vented cylinders are connected, via a vent pipe, to the cold water storage tank which is usually located within the loft space of most properties. How do I know the Size of the thread on my immersion heater brass boss?